Honeywell TELEPHONE ACCESS MODULE W8735D, Owner'S Manual, Page: 8 / 36

8 69-2028—01
Pass Code
When the TAM answers your call, you will be asked to
respond to the voice prompt, “ Please enter your pass
code followed by the # key .”
This is your four-digit pass code. You can change this
pass code any time by entering the Pass Code menu.
See Fig. 4 on page 11.
During installation a unique pass code should have
been set and the number written on the inside of the
TAM cover. For complete instructions see “Pass Code
Menu” on page 14.
NOTE: The TAM’s default pass code are the four
digits - 1 2 3 4.
Alert Messages
The TAM indicates any unacknowledged alert
message immediately after you enter your pass code.
NOTE: If an alert condition still exists but has previ-
ously been acknowledged, the alert is not
repeated.
If there are any unacknowledged alert messages, you
hear this message, “ The (alert description) alert from
(channel/zone) occurred on (date) at (time) .”
See Table 1 for a list of the alert messages and
corresponding causes.
See “Acknowledging Alert Messages” on page 9 to
acknowledge an alert.
For additional information, see “Changing Your
Telephone Access Module Settings” on page 10.
Table 1. Alerts
Alert Description
Power Outage Power was out at this location for more
than 1 hour
Power Restore Power has been restored at this
location
Low Battery Battery has low power or is dead
Auxiliary Input Optional auxiliary input sensor has
tripped
Pass Code Change The pass code has been altered
Low Temperature Limit The room temperature dropped below
the low limit setting
High Temperature Limit The room temperature exceeded the
high limit setting
Outdoor Low
Temperature Limit
The outdoor temperature dropped
below the low limit setting