SPYDER MODEL 7 VAV CONTROLLER INSTALLATION INSTRUCTIONS
31
31-00475-01
Bluetooth LED Status
Controller LED Status
Table 25 Bluetooth LED Status
Mode
LED Status
Visual
BLE disabled by user
OFF
BLE normal operation
and connected
Green, permanently ON.
BLE enabled but not
connected
Green, 2 blinks in 1 s followed by
2 s pause, and repeat.
BLE failure
Red, permanently ON.
Table 26 Controller LED Status
Mode
LED Status
Visual
Firmware download
Green blinks every 200 ms.
No application
a)
Red, Green, Yellow blinks every 1 s.
Broken sensor
Red permanent ON
b)
.
Short circuit
AutoMac
Green blinks every 2 s.
No Valid Mac
Yellow permanent ON.
Un Ack Alarm
Yellow blinks every 2 s.
Normal operation
Green LED permanent ON.
Communication error Red LED blinks every 200 ms.
a)
While performing setpoint balancing using the VAV mobile application, the LED pattern changes from static
green to red, green, yellow cycles (which indicates the controller is empty).
b) For troubleshooting a permanent red LED, navigate to IRM Program > On Board IO and check the UIO function
block OutCase status. A permanent red LED will be illuminated when the OutCase status is SensorOpen (broken
sensor) or SensorClose (short circuit).