Honeywell Solaris MS7820, User Manual

Page: 86 / 210

Scanner Operation D 30
S
ECTION
D J
APANESE
D
OUBLE
F
IELD
S
UPPORT
To support Japanese Double Field Bar Codes, first make sure you have your scanner configured to
the following settings.
•
Disable Segmented UPC Decoding
• Enable 2 scan buffers
• Disable bar code absence detection
• Enable normal code selects
Then, scan the Enable Japan 2 Field bar code.
Enable Japan 2 Field * Disable Japan 2 Field
³ 1 2 4 7 1 3 ³ 1 2 4 7 0 3
Next , select the matching bar codes that are used for double field symbols.
Note that only UPC/EAN bar codes are allowed in double field mode.
Select at least two characters for each bar code. The maximum is 4 upper and 4 lower bar codes.
E
XAMPLE
To select 54 as the first two characters in the Upper Code pair 1:
1. Scan the Upper Code 1 Character 1 bar code ( shown on page D 31 )
2. Determine the correct Code Byte Value for the character 5 in 54
(Refer to Section M’s ASCII Reference Table, starting on page M 6)
a. Scan Code Byte 0
b. Scan Code Byte 5
c. Scan Code Byte 3
3. Scan the Upper Code 1 Character 2 bar code ( shown on page D 31 )
4. Determine the correct Code Byte Value for the character 4 in 54.
a. Scan Code Byte 0
b. Scan Code Byte 5
c. Scan Code Byte 2
To select 18 as the first two characters in the Lower Code pair 1:
1. Scan the Lower Code 1 Character 1 bar code ( shown on page D 31 )
2. Determine the correct Code Byte Value for the character 1 in 18
(refer to Section M’s ASCII Reference Table starting on page M 6)
a. Scan Code Byte 0
b. Scan Code Byte 4
c. Scan Code Byte 9
3. Scan the Lower Code 1 Character 2 bar code ( shown on page D 31 )
4. Determine the correct Code Byte Value for the character 8 in 18.
(Refer to Section M’s ASCII Reference Table, starting on page M 6)
a. Scan Code Byte 0
b. Scan Code Byte 5
c. Scan Code Byte 6