Honeywell SF61, User Manual

Page: 51 / 106

Chapter 2 — Connect the SF61B
SF61 Cordless Scanner User’s Guide 39
If a pairing code or validation is requested, click Enter the
device’s pairing code (or the equivalent command) and enter the
scanner’s pairing code (the default Intermec Bluetooth pairing
code is “0000”)
6 Start the host application you want to connect to and open the
Incoming COM port you noted previously.
When the scanner connects to your host application, it emits a
series of beeps from low to high, and the blue Intermec Ready-to-
Work indicator turns solid blue (default scanner behavior).
Test Your SPP Incoming Connection With the Host
Read the following test code and check that it is correctly displayed by
the host application to make sure that your connection is working
correctly:
Code 39 Test Bar Code
*123456*
*123456*
To Disconnect From the Host
Use the Bluetooth disconnect procedure specific to your host
application to close the Incoming COM port.
When the scanner disconnects from the host PC, it emits a
“disconnect successful” beep sequence (series of beeps from high to
low), and the blue Intermec Ready-to-Work indicator blinks slowly for
5 minutes to indicate it is waiting to connect (default scanner
behavior).
When you open the Incoming COM port again, if the scanner is
switched on it will reconnect to the host application.