User Instructions for the
Sensor Evaluation Kit, SEK002, for Use with
ABP Series (Digital Versions) and MPR Series
Board Mount Pressure Sensors, Honeywell
HumidIcon™ Digital Humidity/Temperature
Sensors, and HPM Series Particle Sensors
32333651
Issue A
Sensing and Internet of Things
1.0 OVERVIEW
The Sensor Evaluation Kit, SEK002, along with the readily-
available components shown in Table 1, and the free evaluation
software available on Honeywell’s website, comprise a simple set
of components used to evaluate the sensors listed in Table 2.
The SEK002 allows the user to obtain sensor readings without
needing to develop any code. The SEK002 is plugged in as a
shield board to the Arduino™ Uno Rev3 Microcontroller Board.
Honeywell evaluation software, downloaded to the user’s PC,
controls the Arduino Uno Rev3 to take sensor readings that are
then displayed on the PC’s screen.
The readings may also be recorded to a .csv file for further
analysis.
Sensors may be mounted directly on the SEK002 or remotely
connected to the SEK002 via wire leads, allowing the sensor to
be tested in adverse environments, or in a prototype product for
proof of concept testing.
2.0 SEK002 AND USER-PROVIDED COMPONENTS
2.1 Assemble the components shown in Table 1.
Table 1. Sensor Evaluation Kit Contents and User-Provided Items
1
Honeywell Sensor Evalution Kit, SEK002
User-Provided Components
I
ncludes:
• Sensor Evaluation Board
• Jumpers for the ABP Series ABPDLNN100MG2A5
preconfigured on the board
Arduino Uno Rev3 Microcontroller Board (A000066)
USB Interface Cable (Type A Male
to Type B Male)
Jumper Wires (for use with
remote connections)
PC with Internet access
(Note: If using a docking station computer, ensure that the
computer is not in its docking station when installing and running
the software.)
1
The Honeywell sensor is not included with the SEK002. The user must purchase the sensor separately.
Jumpers
Jumpers
