4
PX4ie and PX6ie Cutter Kit Installation Guide
8.
Fit the cable from the cutter unit into the DIN connector on the printer’s
front.
9.
Tilt the cutter unit upwards until it locks into place. If the cutter does not
lock properly, the hinges of the cutter unit may need to be adjusted using a
#T10 Torx screwdriver.
10. Plug the printer back in and switch on the power. The cutter will perform an
idle cycle in order to occupy its home position.
11. Switch off the power. Tilt down the cutter and route the paper through the
cutter unit between the guide plates (also see the User’s Guide). Then tilt
up the cutter again and lock it in closed position.
12. Check that the printhead is lowered and switch on the power. Now the
printer is ready for operation.
Press sideways
