Honeywell OWA 100 OneWireless, User Manual

Page: 22 / 51

3. Configuration
3.2. Installation
Rev. 1 OWA 100 Adapter User Manual 11
September 2010
3.2 Installation
1. Loosen the four M4 screws to remove the cover, (See Figure 5-1)
If a new battery needs to be installed follow the directions for Replacing the Battery in Section
5.2.
If a battery is installed remove the shipping tag between the battery and battery holder and replace
the cover.
2. Remove termination cover to which the adapter is to be connected.
3. Remove plastic protective cover on adapter hub
4. Insert wires through conduit entry of the unit to which it is to be mounted then start to thread the
adapter hub into the conduit entry. Use the hex on the adapter hub (smaller hex - See Figure 3-2))
to securely tighten the adapter hub to the unit. To reorient the antenna of the adapter loosen the
jam nut (Turn larger hex nut CC when looking at the front of the OWA 100 Adapter) and rotate
the unit to the desired antenna location then retighten the jam nut. Note: The rotation of the unit
is limited to 350 degrees.
5. Install the four wires per the OWA 100 Adapter Interconnection Diagram per Figure 3-4 to Figure
3-13.
6. Replace the termination cover.
Note: It is the User/Installer's responsibility to install the 100 Adapter in accordance with the national and
local code requirements.
Figure 3-1 Figure 3-2