Honeywell OptiCAM-IR, Installation And Setup Manual, Page: 5 / 16

2-1
S E C T I O N 2
Installing the OptiCAM-IR
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
W W a a r r n n i i n n g g s s a a n n d d C C a a u u t t i i o o n n s s
The following warnings and cautions must be observed when installing and
using the OptiCAM-IR camera.
•
Do not position LED light directly on the eyes when the LEDs are on.
•
Do not use improper power; fire or electric shock could result.
•
Do not disassemble the camera; fire or electric shock could result.
•
In the event that during camera use, a malfunction such as smoke or
extreme heat is detected, immediately stop using the camera; fire or
electric shock could result.
•
Installation should only be accomplished by a qualified service person.
•
Do not disassemble the unit. If a problem occurs within the unit please
contact the service center.
I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
Install the OptiCAM-IR as follows:
1. Attach the mounting bracket (Figure 1) to the camera (Figure 2). Attach
the mounting bracket to the hole below or over the camera tightly.
NOTE : If you want to attach the mounting bracket to the hole over the
camera, you should do that after removing the screw to fix the sun visor
(Figure 3).