Honeywell N86 Series, User Manual

Page: 147 / 218

7 - 15
The following IMGBOX example was executed and viewed using QuickView
software. This software is available at
www.honeywellaidc.com . Click on Soft-
ware Downloads . Select 4600r from the Products list, then select QuickView
Software Utility .
Below is an example of a signature capture application. In this example, the
signature capture area should be centered in the image when the trigger is
pressed. A single beep is emitted, indicating that the engine has read a Code
128 bar code and the data has been transferred to the host. An IMGBOX com-
mand may now be sent from the host to specify the coordinates of the signature
capture area below that code, and indicating that only that area containing the
signature should be transferred as an image to the host.
To see this example, align the signature area (not the bar code) in the center of
the image, then press the trigger.
Send the following IMGBOX command string after the button push:
Example: IMGBOX245w37h55y.
Note: Case is not important in the command string. It is used here only for
clarity.
The following image is captured:
The IMGBOX commands have many different modifiers that can be used to
change the size and appearance of the signature image output by the engine.
Modifiers affect the image that is transmitted, but do not affect the image in
memory. Modifiers always begin with a number and end with a letter (case
insensitive). Any number of modifiers may be appended to the IMGBOX com-
mand.
Note: The IMGBOX command will return a NAK unless a window size (width
and height) are specified. See H - Height of Signature Capture Area
(page 7-17) and W - Width of Signature Capture Area (page 7-18).
IMGBOX Modifiers
A - Output Image Width