13
1.
2.
3.
4.
a.
b.
5.
6.
7.
8.
9.
10.
11.
12.
13.
Set entrance address in
( ).
Address 1
From
dropdown list select type of entrance ( ).
Entrance
2
In
setting group set parameters of entrances disconnection:
Bypass
In
field set period during which entrance will be disconnected ( );
Duration
3
From corresponding dropdown list select time zone during which entrance disconnects automatically ( ).
4
Set delay of bounce of entrance contacts (in seconds) in the corresponding field ( ).
5
If it’s necessary to switch on
function set
checkbox and select necessary object from
and
Auto lock
Allow
Type
N
dropdown lists ( ).
ame
6
If it’s necessary set time zone during which there will be no interactions connected with this entrance ( ).
7
If it’s necessary to require confirmation while activating entrance then set
checkbox, set period of time
Allow
during which the confirmation should be received and select time zone during which the confirmation will be
required ( ).
8
If it’s necessary to activate buffering mode then set
checkbox and select time zone during which this mode
Allow
will be active ( ).
9
If it’s necessary to disable alarm messages then set
checkbox and select time zone during which there will
Disable
be the prohibition (
).
10
Set
checkbox if it’s necessary to substitute
state with
and vice
Alarm/normal state inversion
Alarm
Normal
versa (
).
11
If it’s necessary to limit incoming messages by damage-only messages then set the corresponding checkbox (
).
12
Click
in order to save changes (
).
Apply
13
Setting up entrance is completed.
Creation and setting up of entrance groups
Setting up entrance groups is carried out on setting panel of
object. This object is created on the basis of
N1000 zone
N1
object on
tab of
dialog box.
000 panel
Hardware
System settings
Setting up entrance groups is carried out the following way: