12
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
1.
Set address of exit group in the corresponding field ( ).
1
Set checkboxes opposite those exits that should be in the group ( ).
2
In
setting group set parameters of exit group impulse:
Impulse
In
field set the period during which power supply (impulse) will be given to exit group ( );
Duration
3
From the corresponding dropdown list select time zone during which power supply will be given to exit group
automatically ( ).
4
If it’s necessary set time zone during which there will be no interactions connected with this exit group ( ).
5
If it’s necessary select warning group from the corresponding dropdown list ( ).
6
If it’s necessary set this group as a special group for exit: set
checkbox and select necessary object from the
Allow
list ( ).
7
Click
in order to save changes ( ).
Apply
8
Setting up exit groups is completed.
Setting up HoneyWell N-1000 entrances
Creation and setting up of entrances
Setting up entrances is carried out on setting panel of
object. This object is created on the basis of
N1000 entrance
N10
object on
tab of
dialog box.
00 panel
Hardware
System settings
Setting up entrances is carried out the following way:
Go to setting panel of
object.
N1000 entrance