Honeywell LeaderLine DPR 100 C, Product Manual

Page: 53 / 228

6-7
6. CONFIGURATION
ALARM AN
FUNCTION
PARAMETERS:
SP VALUE
♣ The alarm switches from OFF to ON when the SP value is
reached.
HYSTERES
♣
Establishes the alarm hysteresis. Alarms switch ON at set point
but switch OFF value depends on the hysteresis setting.
Hysteresis is expressed in Engineering units and is added to low
alarm and subtracted from high alarm set points to establish the
alarm release value.
OCCURNCE
Defines the number of alarm occurrences needed after power on
for alarm operation or after start up a new batch.
CHANNEL
Channel on which alarm is applied (Analog 1..6, com 1..6, math
1..6)
AL TYPE
Type of alarm (High, low, differential, ...)
CH DIFF
Second channel used if alarm type is differential.
RELAY #
Selection of relay activated in alarm
ACTION
Action on printer in case of alarm
(None, print on alarm, change range, ...)
MESSAG #
Selection of alarm message to be printed
MSG COL
Multipoint only
Color of alarm message
PRNT MSG
Defines the conditions to print the message on alarm change.
AL = RED
Multipoint only
Specifies if the trace of channel must be printed in red during alarm.
♣
Accessible with the password #1