Honeywell JOSI-DBC012-N11, Installation Manual

Page: 21 / 40

ACUIX
TM
Fixed Dome User Guide
Document 800-01605 Rev A 21
04/08
Note For secure installations, surface-mounted cables should be protected by
plastic or metal cable covers.
Figure 1-8 Power Cable Connection
Installing the Camera Assembly
To install the camera assembly into the ACUIX™base:
1. Loosen all three thumb nuts on the camera chassis (see Figure 1-9 ).
2. Slide the gimbal ring under the two tabs on either side of the thumb nuts on each
bracket (total of 6 tabs).
3. Adjust the camera position. See “Adjusting the Camera” on page 25.
4. Tighten all three thumb nuts to secure the camera assembly.
Make sure that the camera DIP switches are on the top of the lens mount when the
ACUIX™is mounted on the wall or ceiling.
Gimbal assembly
Power supply board
Power/video