![background image](http://html.mh-extra.com/html/honeywell/icon-100-series/icon-100-series_installation-manual_150017013.webp)
ICON 100 SERIES INSTALLATION GUIDE
4. INSTALLATION
4.1 Introduction
The controller must be installed in a place where it is protected from extre-
me vibrations, impacts, water, corrosive gases, steam etc. and where tem-
perature and humidity do not exceed the values given in the technical
specification table (see page 11). The same instructions are also valid for
the probes.
4.2 Thermistor Probe
The thermistor probe must be installed in a place where it is protected from
direct airflow (i.e., away from fans or doors), so that the average
temperature can be measured.
4.3 Defrost Termination Probe
The defrost termination probe must be installed in the coldest area between
the evaporator fins, i.e., where the most ice will form, and not near the
defrost heater or near the area that warms up first during defrosting, in order
to avoid early termination of the defrost cycle.
EN1B-0004UK07 R1003
12