Honeywell HWC-S363-RV, Instruction Manual, Page: 21 / 42

21
PTZ SPEED DOME CAMERAS
10. Move the Joystick to the right at the “SAVE AND EXIT” field to finish title edit menu.
11. Repeat the steps 2 through 10 for each additional preset position.
12. Select
Save And Exit by moving the Joystick to the right. Press ESC to exit the
Preset menu without saving.
NOTE: Press the Home or OFF button at programmed position to delete the preset.
SHORTCUT TO PROGRAMMING PRESETS.
Select direction of the camera, zoom and focus to be programmed, then press No.
(
1~240 ), and then press SHFT , PRST subsequently. The current view will be stored to the
selected preset number if position is empty. If selected preset number is not empty,
“Preset Exist.” message will be displayed on the monitor and you will be prompted to
overwrite.
Example : 1, 0 + PGM + PRST will memorize current view as preset No. 10 . In this case,
focus and Iris mode will be memorized as auto and dwell time will be set to 3 sec.
1.3 Pattern ( MENU => Function => Pattern or Shortcut: PTRN)
The Pattern function memorizes and stores movement of the selected dome camera for up
to 60 seconds. Pattern can be stored in 240 seconds of total recording space. Stored
pattern is played back by pressing
No. + PTRN buttons subsequently.
Follow the steps below to program the Pattern:
1. Press
MENU key to display the main menu on the monitor.
2. Simply press the PTRN key. ( or MENU => Function =>Pattern)
3. Select the empty Pattern number to be programmed by moving the Joystick Up or
Down. If SEC column is not 000, then the selected No. of pattern is already recorded.
4. Press and hold down the SHFT/PGM key while controlling the camera direction and
zoom with the Joystick . The pattern movement will automatically be recorded until
PATTERN SETUP
No. Title Sec
01 : xxxxxxxxxxxxxxxx 000
02 : xxxxxxxxxxxxxxxx 000
03 : xxxxxxxxxxxxxxxx 000
04 : xxxxxxxxxxxxxxxx 000
Total : 000
Exit