Honeywell HRG16, User Manual

Page: 30 / 136

30 | Performance Series DVR User Guide
www.honeywellvideo.com
Configuring the IR Remote Control
Aim the remote control at the IR receiver located at the front of the unit to test operation. If there
is no response, try the following steps:
1. Use the front control panel or the mouse to navigate to
Menu

Settings

General

More Settings .
2. Check and remember the HRG DVR ID number. The default ID number is
255
. This ID
number is valid for all IR remote controls.
3. Press DEV on the remote.
4. Enter the
DVR ID number
from step 2.
5. Press ENTER on the IR remote control.
The Status indicator on the front panel should turn green to indicate that the remote control is
operating properly.
Using a USB Mouse
A regular 3-button (Left/Right/Scroll-wheel) USB mouse can also be used with this HRG DVR.
Connecting a USB Mouse
• Plug the USB mouse into one of the USB ports on the front panel of the HRG DVR.
The mouse should automatically be detected. If, in a rare case, that the mouse is not detected,
pleased refer to the recommended device list from your provider.
USB Mouse Controls
Table 1-3 Mouse Controls
Control Action Result
Left button
Single click Select a menu component, such as a button or an
input field. This is similar to pressing the
ENTER
button on the remote/front panel controls.
Double click Switch between single screen and multi-screen
mode in Live View/ Playback mode.
Click and drag Click and drag the Left mouse button to control the
pan/tilt of a PTZ camera as well as to vary the
position of the digital zoom area and the camera
OSD. It can also be used to setup the alarm areas.
Right button Single click Shows pop-up menu.
Scroll wheel
Scroll up In Live View mode, scrolling up will switch to the
previous screen. In Menu mode, it will move the
selection to the previous item.
Scroll down In Live View mode, scrolling down will switch to the
next screen. In Menu mode, it will move the
selection to the next item.