Honeywell HD4VC4HR, User Manual, Page: 14 / 168

Rev 1.02 8 Document 900.0556
01/06
Figure 5 Gimbal Adjustment
Adjusting the Lens Focus
Lenses are pre-focused at the factory but may require a final adjustment after installation in
the unlikely event the optical effect of the dome causes a slight defocusing of the lens.
TECH TIP! To check the focus, hold the dome over the lens while making any
adjustments.
To adjust the camera direction, view angle and focus, connect the service monitor cable
(supplied) to the video monitor output.
Locking
screw
Set focus
Set focal length
Locking screw. Loosen to
adjust Horizontal (B).
Top view
Angle view
Dip switches
Legend:
A = Tilt rotation
B = Horizontal rotation
C = Pan rotation
B
C
A
Setscrews (x2). Loosen to
adjust Pan (C). Other setscrew
located on opposite side.