Document 800-01529 Rev A
23
02/08
Figure 11
Adding Camera Title Screen
2.
Press the menu control
UP
,
DOWN, LEFT,
or
RIGHT
to select a character, then press
(SETUP)
MENU
to accept it. The character is saved and the title cursor at the bottom of the screen moves
to the next position. You can use the
symbols to go back or forward in the title name to
make changes, and you can also select
CLR
to delete the entire title and start again.
3.
until your camera title is complete.
4.
Select
POS
to position where you would like the camera title to be located on screen. Select the
position using the menu control, then press
(SETUP) MENU
to confirm the position.
5.
Select
END
when you are finished.
Sync Control/Line-Lock Setup
This screen allows you to synchronize the vertical interval sync pulse of your camera with other
equipment to reduce the effect of picture roll on the monitor. Line-Lock mode is only available when
using 24 VAC power.
CAMERA ID
A B C D E F G H I J K L M
N O P R Q S T U V W X Y Z
a b c d e f g h i j k l m
n o p q r s t u v w x y z
– . 0 1 2 3 4 5 6 7 8 9
CLR POS END
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Summary of Contents for HD4DIR
Page 2: ...2 Revisions Issue Date Revisions A 02 08 New document ...
Page 4: ...4 ...
Page 6: ...6 ...
Page 8: ...8 ...
