Honeywell HCE300 Series Manual Download Page 3

Page: 3 / 21

SET UP

MOVING THE HEATER

• The Honeywell Ceramic Tower Heater requires no assembly. Simply unpack heater and save all packaging materials for off-

season storage.

• Place the heater on a firm, level, open surface free from obstructions and at least 3 feet (0.9m) away from any wall or

combustible material.

•

DO NOT

use on an unstable surface such as bedding or deep carpeting.

• BE SURE THE HEATER IS NOT IN A POSITION WHERE IT MAY BE TRIPPED OVER BY CHILDREN OR PETS.

•  This heater is equipped with a Cool Touch handle for your convenience.
•  Turn off the heater.
•  Allow it to cool for ten minutes.
•  Unplug heater and move.

OPERATION

• NOTE: NEVER LEAVE AN OPERATING UNIT UNATTENDED

• With heater in the OFF position ( ), plug the heater into

a polarized 120V outlet.

DO NOT FORCE THE POLARIZED

PLUG INTO THE OUTLET;

it will only fit one way.

• With 80° oscillation, the Honeywell Ceramic Tower Heater

is versatile and designed to be placed in the center of the

room or closer to the wall (at least 3 feet way) for maximum

convection room heating.

• Turn heater on by pressing the Power Button ( ).The Power

Indicator will illuminate and the heater will start in the

Constant On HI Level Setting ( ).

• The heater has two operational modes – continuous heating

or heating with a thermostat setting where the heater cycles

on and off according to the selected temperature setting.

• To set a Continuous Heat Setting, press ( ): - Choose Low ( ) to use 900 watts of power (750 watts on the HCE317 Series only)

- Choose High ( ) to use 1500 watts of power

NOTE:

Because the Low setting does not require as much electricity to operate, it is more energy efficient and may be a better

option if you are concerned about saving energy.

• In the continuous heat mode, make sure to manually turn the heater OFF when done using this appliance.
• To set the Thermostat, press the Thermostat Control Buttons (

) and choose your Desired Temperature. The Desired

Temperature will flash five times and then the Current Temperature in the room will display as a steady red.

NOTE:

If the Current Temperature is higher than your Desired Temperature, the heater will be off until the room temperature falls

below this setting or until the Desired Temperature is changed.

• Press the Timer Button ( ) to select 1, 2, 4, or 8 hour setting. The heater will run for that chosen period in the selected mode,

counting down the hours and automatically shutting the heater off after the selected time has passed.

• Press the Oscillate Button ( ) to to turn on or off the oscillation function.
• To shut the heater off, press the Power Button ( ) and the heater will begin Powering Down. The heater will shut off after counting

down 6 seconds in the Temperature Display to cool down the internal components.

• It is important to allow the heater to run through the cool down phase.

DO NOT

unplug the heater until it has completed the cool

down cycle.

Oscillate Button

Fig. 1

Power

Button

Timer

Thermostat

Control Buttons