GSMX4G
/
GSMXCN4G Installation and Setup Guide
– 24 –
PROMPTS
ENTRY
OPTIONS
DESCRIPTION
45
Restore
Zn8 Y/N
(Y)
only
2-4204
[Y], [N]
Enables restore reporting for
zone 8.
46
Delay Zn8
(secs)
(00)
only
2-4204
[01-15]
[00] = no
delay
Defines the reporting delay in
seconds for zone 8.
47
Review?
Y/N
[Y] =
review
[N] = exit
Reviewing Programming
Mode Entries
To review the programming
options (to ensure that the correct
entries have been made), press
[Y]. The programming prompts
are displayed again. Use the
up/down arrow keys to scroll
through the program fields
without changing any of the
values. If a value requires
change, simply type in the correct
value. When the last field is
displayed, the “REVIEW?”
prompt again appears.
To exit the programming
mode
, press [N] in response to
the "REVIEW?" prompt, and refer
to
Exiting Programming Mode
topic.
ECP Status Codes
The communicator sends status messages to the control panel to report
various failures. Some control panels, (e.g., VISTA-10P, VISTA-15P and
VISTA-20P Series) display these status codes on the keypad as “LngRng
Radio” followed by a 4-digit code. Commercial panels can supervise the
communicator by way of its ECP address, ex: 03. For example, if the
communicator is disconnected, if it's not registered, or the SIM is deactivated,
a "Check 803" will be displayed.
The control panel will display a fault message if any of the events listed
below occur.
•
Module lost communications with the control panel.
Summary of Contents for GSMX4G
Page 38: ...Notes ...
