ROME Series Installation Document —
P/N 53530:B 9/14/2009
3
Mounting an Optional Second Relay Module in the ROME Series
ANN-MBRLY Mounting Bracket Installation
An optional second Relay Module can be mounted inside the ROME Series using the ANN-MBRLY mounting bracket.
Two holes must be drilled in the enclosure to secure the ANN-MBRLY as described in the following steps:
1. Place the ANN-MBRLY mounting bracket flat against the inside back wall of the ROME Series, while positioning
two oblong holes over the mounting studs as shown in the following illustration.
2. Make a mark on the ROME Series back wall using the two holes that will be used to secure the ANN-MBRLY as a
guide.
3. Remove the ANN-MBRLY from the ROME Series and drill two 3/32” (dia. 0.093”) holes in the locations marked in
step 2. Note that these holes will be used to secure the ANN-MBRLY using the two supplied self-tapping screws.
4. Place the ANN-MBRLY mounting bracket oblong holes in position over the mounting studs and install the two
supplied nuts, but do not tighten at this time.
5. Install the two supplied self-tapping screws in the locations indicated and secure the ANN-MBRLY to the ROME
Series using the holes drilled in step 3.
6. Tighten the two nuts installed in step 4.
self-tapping screw
oblong mounting hole
mounting stud
(with nut)
drill 3/32” (dia. 0.093”)
hole in ROME Series for
self-tapping screw
ANN-MBRLY
Mounting Bracket
self-tapping screw
oblong mounting hole
mounting stud
(with nut)
drill 3/32” (dia. 0.093”)
hole in ROME Series for
self-tapping screw
ROME Series
