Honeywell FF-LS082802362, Installation Manual

Page: 14 / 46

107022-16 EN FR26 GLO 301 Printed in Germany
14
3.
Installation
3.1. Overview
This chapter contains information about properly installing a FF-LS safety light curtain including how to calculate the safety
distance and mounting considerations.
FULL REVOLUTION MECHANICAL POWER PRESSES CANNOT BE STOPPED IN MID-STROKE (OSHA 29CFR
1910.217).
Do NOT use FF-LS Series safety light curtains on full revolution mechanical power presses.
Failure to comply with these instructions will result in death or serious injury.
IMPROPER POINT-OF-OPERATION PROTECTION
Install FF-LS safety light curtains and fixed barriers so that NO person can stand between light curtain and danger zone
without being detected.
Failure to comply with these instructions will result in death or serious injury.
IMPROPER INSTALLATION OF FF-LS SERIES LIGHT CURTAIN
Install FF-LS safety light curtains in accordance with this installation manual and applicable local safety regulations (OSHA,
ANSI, European standards).
Mount FF-LS Series safety light curtains so that any entry into protected area must interrupt sensing field or activate other
safeguarding devices.
Install fixed barrier or additional safety light curtains to prevent operating personnel from reaching around, under, or over the
sensing field.
Failure to comply with these instructions could result in death or serious injury.
IMPROPER SYSTEM PERFORMANCE
Comply with local safety requirements when designing the machine control interface and all the control elements that affect
safety.
Ensure the BEAM NUMBER on the red label located on the sensing units (A and B) and the control unit are ALL THE
SAME.
Install two independent safety relay contacts into machine control stop circuit controlled by FF-LS Series safety light curtain.
Ensure two independent stop circuit relays have mechanically linked contacts to reliably detect a welded contact.
Failure to comply with these instructions could result in death or serious injury.
IMPROPER MACHINE REACTION
Ensure the machine control is capable of stopping the machine at any point in the cycle.
Ensure that a loss of power does NOT impair stopping action of machine.
Failure to comply with these instructions could result in death or serious injury.