Honeywell EQUIP Series, Installation And Configuration Manual

Page: 25 / 148

EQUIP
®
Series ACUIX™ IP PTZ Dome Installation and Configuration Guide
Document 800-04194V1 Rev A 7
07/11
To install a wall mount:
1. Route the field wiring through the base of the mount and leave
approximately 1 ft. (0.3 m) extending past the end of the mount. Optionally,
you can route the wiring through the 0.75 in. (19 mm) conduit hole at the
base of the mount arm.
2. Attach the mount to the mounting surface using appropriate mounting
hardware.
3. For outdoor wall mount installations, apply sealant (not supplied) to any
gaps between the mount and the mounting surface, and ensure that the
conduit hole plug is in place when the conduit hole at the base of the mount
arm is not in use.
To install a wall mount with a corner or pole adapter:
1. Route the field wiring through the wiring access hole in the adapter.
2. Attach the adapter to the mounting surface using appropriate mounting
hardware.
3. Route the field wiring through the base of the mount and leave
approximately 1 ft. (0.3 m) extending past the end of the mount. Optionally,
you can route the wiring through the 0.75 in. (19 mm) conduit hole at the
base of the mount arm.
4. Attach the mount to the adapter using appropriate mounting hardware.
5. For outdoor wall mount installations, apply sealant (not supplied) to any
gaps between the mount, adapter, and the mounting surface, and ensure
that the conduit hole plug is in place when the conduit hole at the base of
the mount arm is not in use.
Installing a Roof Mount
The HDPRM2 parapet/flat roof mount can be installed directly to a vertical
(parapet) or horizontal (flat roof) load-bearing surface (see
Figure 2-3 ). The
mount has a maximum load rating of 20 lb. (9 kg) and can withstand winds up
to 75 mph (121 km/h) when properly fastened to a support structure.
Figure 2-3 HDPRM2 Parapet/Flat Roof Mount
Parapet
Roof