Honeywell EConnect TL9160AR, Installation Manual, Page: 10 / 80

System Installation Guide
69-2474EFS—01 10
Link outdoor sensor to wireless network (optional)
1 Make sure the Connect light on the EIM is
flashing (see page 7).
If you have more than one wireless thermostat,
make sure to activate the wireless setup from
an EIM linked to the thermostat. For example, to
display the outdoor temperature on thermostat
Y, you must activate the wireless setup from
either EIM B or C, not A.
2 Press the
CONNECT
button on the back of the sensor.
3 After 15 seconds, check if the thermostat is displaying a value for the outdoor
temperature reading.
If you have more than one wireless thermostat, repeat steps 1 and 3 for each
thermostat.
Press and
release
Link remote control to wireless network (optional)
1 Make sure the Connect light on the EIM is flashing (see page 7).
If you have more than one wireless thermostat, make sure to activate the wireless
setup from an EIM linked to the thermostat. For example, to link the remote control to
thermostat Y, you must activate the wireless setup from either EIM B or C, not A.
2 Press CONNECT at the remote control.
3 When the remote control displays
Connected
(after a short delay), press DONE .
4 Press NO at the next screen to save and exit.
(Or press YES and repeat steps 1-4 to link to
another network).
Remote
control
Thermostat X
Thermostat Y
EIM A
EIM B EIM C
Outdoor
sensor
Bathroom
wireless network
Bedroom
wireless network
CONNECT
WIRELESS SETUP
NO YES
CONNECT MORE?
Press to save
and exit
Press to link to
another network