10
LIGHT KIT INSTALLATION
Screw
Screw
15.
To install the fan with light kit:
Remove screws from the fitter plate. Then connect
the plug from the motor assembly to the plug from
the light kit, matching the colors on each plug.
Ensure that the plugs connect tightly (Fig. 15).
Remove the screws from the fitter plate. Align
holes in switch housing with holes in upper switch
housing. Reinstall screws that were previously
removed. Use a Phillips screwdriver (not included)
to secure all screws. Plug the hole in the switch
housing with the plastic cap (Fig. 14B). Proceed to
step 20.
Plastic Cap
Nut
Washer
14.
(Optional) To install the fan without a light kit:
Disconnect the single-pin connectors inside the
switch housing labeled “for light kit connection”
-- black from blue and white from white. Then,
remove the nut and washer located from the
threaded rod in the center of the switch housing to
remove the light kit and wiring (Fig. 14A).
Fig. 14B
Fig. 15
Switch
Housing
Switch
Housing
Plug
Plastic Cap
Screw
Screw
Fig. 14A
Light Kit
Washer
Hex Nut
Switch
Housing