Page5
Fig.1
6.Do not kink the power cord.
7.This unit is approved for use over a bathtub or shower when installed in a GFCI protected
branch circuit.
8.This unit must be grounded.
9.This unit is U.L. Listed. Type I.C. Inherently protected.
10.These models are UL listed for tub and shower enclosures.
11.Provide suction parts with proper ventilation.
12.Do not install the unit where ducts are configured as shown in Fig.1.
GENERAL SAFETY INFORMATION
TO REDUCE THE RISK OF FIRE ,ELECTRIC SHOCK,OR INJURY TO PERSONS, OBSERVE
THE FOLLOWING:
1.Use this unit only in the manner intended by the manufacturer. If you have questions,
please contact the manufacturer at the address or telephone number listed in the
warranty.
2.Before servicing or cleaning unit, switch the power off at service panel and lock the
service disconnecting means to prevent power from being switched on accidentally.
When the service disconnecting means cannot be locked, securely fasten a prominent
warning device, such as a tag, to the service panel.
3.Installation work and electrical wiring must be done by a qualified person(s) in accordance
with allapplicable codes and standards, including fire-rated construction codes and
standards.
WARNING:
4.Sufficient air is needed for proper combustion and exhausting of gases through the flue
(chimney) of fuel burning equipment to prevent backdrafting. Follow the heating
equipment manufacturer's guideline and safety standards, such as those published by
the National Fire Protection Association (NFPA) and the American Society for Heating,
Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities.
5.When cutting or drilling into wall or ceiling, make sure not to damage electrical wiring and
other hidden
utilities.
6.Ducted fans must always be vented to the outdoors.
7.NEVER place a switch where it can be reached from a tub or shower.
8.Solid state controls may cause harmonic distortion that can cause motor humming noise.
9.To reduce the risk of fire or electric shock, Do not use this fan with any solid-state speed
control device.
10.Not to be in a ceiling thermally insulated to a value greater than R40.
11. Fluorescent models only: Do not use a dimmer switch to control the light of this unit.
12. Motor and grille assembly must be installed with housing assembly that are marked (on
their cartons) to indicate the suitability with this model. Other housing assembly cannot
be substituted.
13. To reduce the risk of fire use only these 26 watt fluorescent lamps and 4watt maximum
type C incandescent lamp nightlight.
GENERAL ELECTRIC: F26DBXT4/SPX27/4P
PANASONIC: FDS26E27/4
LONON: YDW2U26C/120, YDW2U26D/120
