43-TV-33-214 iss.2 GLO May 2015 UK
1
DR Graphic recorder - Installation Instruction
Display Replacement
DR Graphic Recorder
This Installation Instruction sheet is intended as a guide for replacing or installing hardware and for setting up
functionality in the recorder. Refer to the User manual for detailed operational requirements.
The DR Graphic recorders are designed for ease of assembly with minimal disturbance to the rest of the unit. If unsure,
please return the unit to your supplier for repair or upgrade.
Opening the recorder and removing the internal chassis of the recorder should only be performed under the following
circumstances:
When an item of hardware requires individual replacement.
When an item of hardware is to be retrospectively fitted.
In all other instances it is recommended that the complete unit be returned to an authorized agent or service centre. For
Agency Approved recorders the product needs to be upgraded or repaired by an Authorized Repair facility
WARNING
HAZARDOUS VOLTAGES
Disconnect all the power, CJCs and IO cabling to the recorder before removing the IO cards chassis or power supply
chassis and attempting any maintenance procedures.
SAFETY TESTS
Upon completion of service procedures detailed in this instruction verify the installation per the installation section of the
product manual.
Failure to comply with these instructions could result in death or serious injury
CAUTION
OBSERVE ANTI-STATIC PRECAUTIONS
Refer to BS EN61340-5-1: 2001. Basic specification. Protection of electrostatic sensitive devices.
Full anti-static precautions MUST be observed when in contact with the electronics of your recorder.
SAVE DATA, SETUPS AND LAYOUTS
Removal of PCBs and battery back-up will result in the loss of all non-volatile data.
Ensure all data and set-ups are saved.
Failure to comply with these instructions may result in product damage.
