7
c.
Once the required time is reached press the green
button to confirm.
Note:
If the original time setting did not require adjustment press the green
button to move to step
‘d’
.
d.
The temperature setting for period
1
on Monday (Day 1) will now be flashing. To
adjust this press the or
buttons and confirm the setting again by pressing
the green
button.
e.
The next time and temperature period will now be active. Adjust this by repeating
steps b - d above until all 4 periods are set for Monday or press the
AUTO
button
to run the program as set, at any time.
You now have a choice of how to set the program for the next day:
f.
i)
Press the
COPY DAY
button to copy Monday’s program into Tuesday. The
display will go blank apart from the ‘non flashing’ day indicator, which indicates
the day copied and the ‘flashing’ target day to copy the program to. To accept this
day press the green
button. To select a different target day press the
DATE/
DAY
button until the ‘flashing’ day indicator is under the required day, then accept
it by pressing the green
button.
Note:
Once the target day is confirmed it
becomes the day that is copied if the
COPY DAY
button is pressed again.
OR
ii)
Press the
DATE/DAY
button to move the day indicator to Tuesday (Day 2). The
program for that day can then be adjusted by following steps
b to e
. Programs
for the remaining days can be set in the same way, using the
DATE/DAY
button to
move to the next day.
To exit the programming mode select the desired operating mode by pressing the
AUTO
,
MAN
or
OFF
buttons.
Note:
To run the adjusted program select the
AUTO
mode.
Disabling / Enabling Time Periods
The thermostat has 4 periods each day that can be programmed, but you may not
need all of these switch points for your heating requirements. Therefore, any period
from 2 to 4 can be removed from (or returned to) the heating program profile.
To disable or enable time periods:
a.
To disable unwanted periods go to the desired period (
2
to
4
) using the
PROGRAM
or
buttons to navigate, ensure the correct period is highlighted
with the flashing square symbol. Press and hold the button for at least 2 seconds
and the display will indicate the period has been removed from the program.
b.
To enable periods again follow the same procedure as above, navigating to the
already disabled period. To enable this period again press and hold the button
for at least 2 seconds.
PROGRAMMING THE CM707
