Honeywell Bendix/King KX 165A, Maintenance Manual

Page: 77 / 297

BENDIX/KING KX 165A
Rev 0, Jun/2000 15610M00.RCD Page 5-29
TEST DATA SHEET
2. Modulation Capabilities:
Input a standard modulator test signal into the microphone audio. See Figure 5-3.
The transmitter output should go to either a modulation analyzer or oscilloscope.
Ensure that the transmitter is terminated into a 50
Ω
load capable of dissipating at
least 15W.
*a. 118.00 MHz: _________ NLT 70%
126.50 MHz: _________ NLT 70%
136.97 MHz: _________ NLT 70%
b. Carrier Noise Level:
Modulate the carrier with 70% at 1000 Hz. Noise on the carrier with mod-
ulation removed shall be NLT (use linear detector shown in
Figure 5-4 ):
118 MHz _________ > 35 dB
126.5 MHz ________ > 35 dB
136.95 MHz ________ > 35 dB
c. Demodulated Audio Distortion. This is an optional test that requires a dis-
tortion analyzer and the linear detector shown in fig 5-4
Distortion
350 Hz ______________
≤
15%
1 kHz ______________
≤
15%
2.5 kHz ______________
≤
15%
d. Headphone Sidetone:
Input a 1000 Hz, tone into the microphone audio and adjust its level to pro-
duce 70% mod. Make sure the NAV volume control is set fully counter-
clockwise. Monitor the Comm Audio output (loaded with 500
Ω
). Go to
alignment mode and adjust SIDE from minimum (000) to maximum (256).
_________ 0.003 Volts (Min)
__________ 7.07 Volts (Max.)(Measured with 500 Ohm load)
__________ Set SIDE for 1.40 V at end of test.