FAN OPERATION
• To use the unit as an air circulator without heat, turn the selector knob to FAN and the
thermostat to its highest setting.
IF YOUR HEATER FAILS TO OPERATE:
• Be sure it is plugged in and that the electrical outlet is working.
• Check for any obstruction. If you find an obstruction turn the heater OFF. Unplug the heater
and wait at least ten minutes for it to cool. Carefully remove the obstruction. Plug the
heater back in and restart it as described under OPERATION.
• Check that the thermostat is not set too low. With the “selector” knob set to a heat setting,
turn the thermostat up (clockwise) until the heater restarts.
• Be sure heater is on a flat surface and in an upright position.
NOTE: IF YOU EXPERIENCE A PROBLEM WITH YOUR HEATER, PLEASE SEE THE WARRANTY FOR
INSTRUCTIONS. PLEASE DO NOT ATTEMPT TO OPEN OR REPAIR THE HEATER YOURSELF. DOING
SO MAY VOID THE WARRANTY AND COULD CAUSE DAMAGE OR PERSONAL INJURY. IF THE
PROBLEM STILL PERSISTS, PLEASE CALL:
Kaz Home Environment - Consumer Relations Dept.
Mail questions and comments to:
Kaz Home Environment
Consumer Relations Department
250 Turnpike Road
Southborough, MA 01772
USA
Toll Free: 1-800-332-1110
E-mail: [email protected]
Please be sure to specify model number.
Visit us at www.kaz.com
CLEANING AND STORAGE
It is recommended that the heater be cleaned at least once a month.
ALWAYS TURN THE
POWER SELECTOR OFF AND UNPLUG THE HEATER BEFORE CLEANING.
Save the box for off-
season storage.
• Turn the heater OFF, unplug it, and wait for the heater to cool.
• Use a dry cloth to clean only the external surfaces of the heater.
DO NOT USE WATER, WAX OR POLISH
• Pack the heater in its original carton and store it in a cool, dry place.
