LYNXR-I Installation and Setup Guide
- 30 -
✻
56 Enhanced Zone Programming Mode
While in Program mode, press
✻
56 to enter Zone Programming Menu Mode.
Refer to the zone assignment table for
✻
56 on the separate programming form.
The following explains the
✻
56 prompts in detail. The left two columns identify the prompts and list the
available entries for each. The right-most column provides a further explanation of the entries.
Note:
You may find it convenient to adjust the volume setting before entering the Programming Mode. This will allow you to clearly hear
feedback announcements or system beeps.
A 02
Zone number
02-41, 95, 96, 99 = Zone number
[
✻
] = continue
00 = exit Zone Programming mode
Enter the 2-digit zone number to be programmed and the Voice
Descriptor for the selected zone number will be announced, if it is
programmed. Press [
✻
] to advance.
•
Zones 02-25 = RF zones (only)
•
Zones 26-41 = Button zones (only)
•
Zone 92 = Duress
•
Zones 95, 96, 99 = Panic zones
Pressing 00 exits mode, upon which the prompt “56” blinks, indicating
the mode is inactive. Press [
✻
] + any field number to go to that field.
b
zt
Zone type
00-24 = zone type
[
✻
] = continue
[#] = return to previous prompt
Note:
If 00 is accepted as a zone type, save the 00
zone type and advance to the confirm delete
prompt (F).
Each zone must be assigned to a zone type, which defines the way in
which the system responds to faults in that zone. Enter the 2-digit zone
type for this zone as follows:
00 = Not Used
08 = 24 Hr Aux
01 = Entry/Exit #1
09 = Fire without verify
02 = Entry/Exit #2
10 = Interior w/Delay
03 = Perimeter
20 = Arm–Stay
04 = Interior Follower
21 = Arm–Away
05 = Trouble Day/Alarm Night
22 = Disarm
06 = 24 Hr Silent
23 = No Alarm Response
07 = 24 Hr Audible
24 = Silent Burglary
C
rc
Report code
Enter the report code for this zone.
[
✻
] = continue
[#] = return to previous prompt
The report code consists of 2 hexadecimal digits, each in turn consisting
of 2 numerical digits. For example, for a report code of "3C", enter [0][3]
for "3" and [1][2] for "C".
If this isZone 95, 96 or 99, the system skips to the VOICE
DESCRIPTOR prompt (1C).
d
i
Input type
3 =RF (supervised RF) – sends periodic
check-in signals, faults, restore and low
battery signals
Note:
RF type transmitters must remain within range
of the receiver, otherwise a supervision failure
signal will occur.
4 = UR (unsupervised RF) – sends same as
“RF” type, but control does not supervise
the check-in signals
5 = BR (button type) – sends only fault and low
battery signals; does not send restores or
check-in signals
Note
UR and BR type transmitters may be carried off
premises (out of range without causing a
supervision failure.
[
✻
] = continue
[#] = return to previous prompt
Enter the input type for the transmitter assigned to this zone. Refer to
the transmitter’s instructions for input types of each transmitter.
Note:
Zones 2-25 should be assigned Input Type 3 or 4 . Zones 26-41
should be assigned Input Type 5 only.