2
6.
Install the antennas
in the
right-hand
terminals of
the two terminal blocks at the upper edge of the circuit
board, one into each block’s right-hand terminal, and
tighten the screws to secure them.
If the receiver is mounted in a cabinet, insert the
antennas through the holes in the cabinet's top first,
and then into the terminal blocks.
7.
Replace the receiver's cover
if the receiver is not
mounted within a cabinet.
8.
Proceed with any programming of the control
that may be necessary for RF operation, and the
installation of the system's wireless transmitters,
as described in the control's installation instructions.
9.
The LED located on the receiver's circuit board
should be used as an indicator of strong local radio
frequency interference. If this LED is continuously
illuminated, the receiver should be relocated.
SPECIFICATIONS
Operating Frequency:
315 MHz
Dimensions:
188mm W x 112mm H (277mm w/antennas) x 37mm D.
Input Voltage:
12VDC (from control’s remote keypad terminals).
Current:
60mA.
0perating Temperature:
0°C – 50°ÁC
Interface Wiring:
RED 12VDC input (+) Aux Power
GREEN: Data Out to Control
YELLOW:Data In from Control
BLACK:
Ground
(–)
Range:
60m nominal indoors from wireless transmitters (the
actual range to be determined with the security system
in Figure 2).
TO THE INSTALLER
Regular maintenance and inspection (at least annually) by
the installer and frequent testing by the user are vital to
continuous satisfactory operation of any alarm system.
The installer should assume the responsibility of developing
and offering a regular maintenance program to the user, as
well as acquainting the user with the proper operation and
limitations of the alarm system and its component parts.
Recommendations must be included for a specific program
of frequent testing (at least weekly) to ensure the system's
operation at all times.
MOUNTING
CLIP
CABINET
DETAIL D
ANTENNA AND GROUNDING LUG INSTALLATION
ANTENNA
MOUNT
(2 PLACES)
ANTENNA
(2)
SCREW
(2)
MOUNTING
CLIP
CONTROL
CIRCUIT
BOARD
BOARD
SUPPORTING
SLOTS
HOLES FOR ANTENNAS
AND GROUNDING LUGS
RECEIVER CIRCUIT BOARD
(See Detail D)
+
+
+
+
RCVR BRD
DETAIL A
SIDE VIEW
OF BOARD
SUPPORTING SLOTS
DETAIL B
SIDE VIEW
OF MOUNTING
CLIP
DETAIL C
SIDE VIEW
OF MOUNTING
CLIP
GROUNDING
LUG
(2)
pcb_RF_mount-V0
CIRCUIT BOARD
CABINET
Figure 1: Installing the Receiver Board in the Control’s Cabinet
