background image

 

 
 
 
 
 
 
 
 

 

ADEMCO LIMITED WARRANTY 

Alarm Device Manufacturing Company, a Division of Pittway Corporation, and its divisions, subsidiaries and affiliates 
("Seller"), 165 Eileen Way, Syosset, New York 11791, warrants its products to be in conformance with its own plans 
and specifications and to be free from defects in materials and workmanship under normal use and service for 24 
months from the date stamp control on the product or, for products not having an ADEMCO date stamp, for 12 months 
from date of original purchase unless the installation instructions or catalog sets forth a shorter period, in which case the 
shorter period shall apply. Seller's obligation shall be limited to repairing or replacing, at its option, free of charge for 
materials or labor, any product which is proved not in compliance with Seller's specifications or proves defective in 
materials or workmanship under normal use and service. Seller shall have no obligation under this Limited Warranty or 
otherwise if the product is altered or improperly repaired or serviced by anyone other than ADEMCO factory service. 
For warranty service, return product transportation prepaid, to ADEMCO Factory Service, 165 Eileen Way, Syosset, 
New York 11791. 

THERE ARE NO WARRANTIES, EXPRESS OR IMPLIED, OF MERCHANTABILITY, OR FITNESS FOR A 
PARTICULAR PURPOSE OR OTHERWISE, WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE 
HEREOF. IN NO CASE SHALL SELLER BE LIABLE TO ANYONE FOR ANY CONSEQUENTIAL OR INCIDENTAL 
DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESS OR IMPLIED, OR UPON ANY OTHER 
BASIS OF LIABILITY WHATSOEVER, EVEN IF THE LOSS OR DAMAGE IS CAUSED BY THE SELLER'S OWN 
NEGLIGENCE OR FAULT. 

Seller does not represent that the products it sells may not be compromised or circumvented; that the products will 
prevent any personal injury or property loss by burglary, robbery, fire or otherwise; or that the products will in all cases 
provide adequate warning or protection. Customer understands that a properly installed and maintained alarm may only 
reduce the risk of a burglary, robbery, fire or other events occurring without providing an alarm, but it is not insurance or 
a guarantee that such will not occur or that there will be no personal injury or property loss as a result. 
CONSEQUENTLY, SELLER SHALL HAVE NO LIABILITY FOR ANY PERSONAL INJURY, PROPERTY DAMAGE OR 
OTHER LOSS BASED ON A CLAIM THE PRODUCT FAILED TO GIVE WARNING. HOWEVER, IF SELLER IS HELD 
LIABLE, WHETHER DIRECTLY OR INDIRECTLY, FOR ANY LOSS OR DAMAGE ARISING UNDER THIS LIMITED 
WARRANTY OR OTHERWISE, REGARDLESS OF CAUSE OR ORIGIN, SELLER'S MAXIMUM LIABILITY SHALL 
NOT IN ANY CASE EXCEED THE PURCHASE PRICE OF THE PRODUCT, WHICH SHALL BE THE COMPLETE 
AND EXCLUSIVE REMEDY AGAINST SELLER. This warranty replaces any previous warranties and is the only 
warranty made by Seller on this product. No increase or alteration, written or verbal, of the obligations of this Limited 
Warranty is authorized. 

 

Summary of Contents for ADEMCO 5881EN Series









Reviews: