Honeywell ADEMCO 5843 Installation And Setup Manual Download Page 3

 

 
 

Federal Communications Commission (FCC) Part 15 

The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or User's Manual.  

Unauthorized changes or modifications could void the user's authority to operate the equipment. 

CLASS B DIGITAL DEVICE STATEMENT 

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These 

limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can 

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio 

communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful 

interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the 

interference by one or more of the following measures: 

 

Reorient or relocate the receiving antenna. 

 

Increase the separation between the equipment and receiver. 

 

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

 

Consult the dealer or an experienced radio/TV technician for help. 

This Class B digital apparatus complies with Canadian ICES-003. 

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

 

FCC/IC STATEMENT  

This device complies with Part 15 of the FCC rules and RSS 210 of Industry Canada. Operation is subject to the following two conditions: (1) This 

device  may  not  cause  harmful  interference,  and  (2)  This  device  must  accept  any  interference  received,  including  interference  that  may  cause 

undesired operation. 
Cet appareil est conforme 

à

 la partie 15 des r

è

gles de la FCC & de RSS 210 des Industries Canada. Son fonctionnement est soumis aux conditions 

suivantes: (1) Cet appareil ne doit pas causer d' interferences nuisibles. (2) Cet appareil doit accepter toute interference re

ç

ue y compris les 

interferences causant une reception ind

é

sirable. 

 

 

 

 

 

 

Summary of Contents for ADEMCO 5843

Page 1: ...s disconnected Due to shocks or vibration during shipment and installation the out of box state of these relays may be either open or closed When power is first applied the relay will be set to its correct initial state Please bear this in mind during installation it is strongly recommended that you wire this module and apply power to it before energizing any external circuit controlled by the lat...

Page 2: ...s the button to be enrolled twice Verify that the red LED turns off 5 Place DIP switch 3 in the ON position 6 Press and release the button that will be used to operate the switch Verify the red LED flashes 3 times Note If an incorrect wireless transmitter is enrolled set DIP switch 3 to OFF and repeat the enrollment procedure from step 4 7 To add an additional button on the same key repeat step 6 ...

Page 3: ...equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help This Cl...

Page 4: ...ev C For the latest warranty information please go to http www security honeywell com hsc resources wa index html 2 Corporate Center Drive Melville NY 11747 Copyright 2007 Honeywell International Inc www honeywell com security ...

Reviews: