___ __________________________ Honeywell
Technical Support Inside
Step by Step
Created by Jim Venero
9/20/06
8
SWITCHING YOUR JUMPER
Follow the previous instructions for taking apart your 7720P programming tool
With a pair of needle nose pliers pull the jumper out from the 12V position and insert it
into the 6V position. You will see a small 6V and 12V written on the circuit board. 6v
would be the center and bottom hole if facing the programming tool.
**NOTE – A NEW 7720p PROGRAMMING TOOL DOES NOT HAVE A JUMPER
WHICH MEANS IT WILL WORK ON THE 6V OR 12V SETTING MANUALLY
DEPENDING ON WHAT DEVICE YOU ARE PLUGGED INTO.
If you need further assistance call us at Honeywell/AlarmNet Division 800-
222-6525
