Honeywell 5900 RFID, User Manual

Page: 64 / 70

9 - 6
2. Plug the CAT-5 Ethernet cable into the RJ45 connector on the back of the eBase.
3. Plug the Ethernet cable into the network.
4. Insert the Optimus 5900 RFID terminal into the terminal well.
Note: Instead of using the default for DHCP assigned IP addresses, the Optimus 5900 RFID terminal can use a
statically assigned IP address. See standard Microsoft Windows Mobile documentation for how to assign a
static IP address to a network adapter. In this case, set a static IP address for the adapter named "SMC95001
USB2.0 FAST Ethernet Drive".
Establishing USB Communication
Optimus 5900 RFID terminal’s support USB communication out of the box. The eBase also supports USB
communi-cations using the USB port located on the back panel of the eBase. The eBase acts as a USB
device by interfacing the USB signals of the Optimus 5900 RFID terminal to the USB of the host
workstation. Using a standard USB cable, the ebase’s USB interface allows the Optimus 5900 RFID
terminal to communicate with a host workstation.