Excluding the SSA1 Siren/Strobe module
!
This procedure may ONLY be used in the event that the SSA1 Siren is not operating properly, has lost
communication with the control or if the 5877 Relay Receiver has been replaced.
ACTION
NOTES
1. At the Home or Dashboard screen select the “Automation” icon.
Note:
Depending upon the control panel that is being connected the Garage
Door Setup icon is located on either the first or second page of the
Automation Screen.
2. Select the Garage door setup icon.
3. Select the desired Garage door, from the displayed list.
4. At the Garage Door setup screen, select Exclude Siren **” to exclude the
SSA1 siren/strobe module.
5. The panel displays “Entering Exclusion Mode. Please wait…” followed by
“Ready to Exclude device.” Press the function button on device.” Within
one minute press the siren’s Function button.
6. If the module has been successfully excluded, the panel displays the
device information.
Note:
If the SSA1 is shared with additional garage doors it will be excluded
from each of those doors.
7. Select the “
” button to return to the Automation screen.
8. Include the SSA1 by repeating steps 8-11 of the “Enrolling the 5877 Relay
Receiver and Including the SSA1 Siren/Strobe module” above.
•
If a single SSA1 Siren/Strobe Module that has
been included on multiple garage doors is
excluded, it will be excluded from ALL garage
doors that it had previously been included with.
Garage Door Feature Operation
ACTION
NOTES
1. At the Home or Dashboard screen select the “Automation” icon.
2. At the Automation Screen, select the Garages icon.
3. Select the Garage door that you wish to control/program from the
displayed list. The control advances to the Garage Door operation screen.
4. Refer to the procedures below for additional operation/programming
information.
•
The Garage Zone and Response Type must be
assigned in order to view garage door status.
Control Panel Garage Door Opener Operation
Ready To Arm
5200-100-128-V0
Garage Door 1
OPENED
Press to close
Edit
Back
Close in
Close at
Ready To Arm
lyric-069-V0
Edit
Close at
Press to close
Not Applicable to Lync Gateway
Close in
LYNX Touch
Lyric Controller/Lyric Gateway
Garage Door Operation Screens
Button or Icon
Function
Edit
Used to modify description of Garage Door
Close in*
Provides access to keypad used to set a specific period of time (up to 12 hours and 59 minutes)
before an open garage door closes automatically. If programmed the time will also be displayed.
Close at*
Provides access to keypad used to set a specific time that an open garage door closes
automatically. If programmed the time will also be displayed.
Back
Used to return the control to the Garage Door list.
OR
Press to open
Indicates Garage Door is Closed. Used to Open Garage Door.
OR
Press to close
Indicates Garage Door is Open. Used to Close Garage Door.
