background image

 

 

SPECIFICATIONS: 

Physical:   
 

6-1/4” W x 4-3/4” H x 1-3/8” D (159mm x 121mm x 35mm)

 

Frequency of Operation: 

345 MHz

 

Batteries: 

3 AA, 1.5 Volt Alkaline, ADEMCO part no. 468 
Anticipated battery life is 1.5 years.

 

Power Pack/ 
Desktop Mounting Kit 
(optional): 

110VAC input, 5.0 Volt Regulated DC output, 220mA, 
ADEMCO P/N 5828DM

 

Display: 

Fixed-Word Liquid Crystal

 

Sounder: Speaker

 

 

 
 

 
 
 

FCC & INDUSTRY CANADA STATEMENT

 

T

HIS DEVICE COMPLIES WITH PART 15 OF FCC RULES AND RSS210 OF INDUSTRY CANADA.  OPERATION IS 

SUBJECT TO THE FOLLOWING TWO CONDITIONS:  (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, 
AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY 
CAUSE UNDESIRED OPERATION.   
 
THE USER SHALL NOT MAKE ANY CHANGES OR MODIFICATIONS TO THE EQUIPMENT UNLESS AUTHORIZED BY 
THE INSTALLATION AND SETUP GUIDE OR USER GUIDE.  
 

 
 

FOR WARRANTY INFORMATION AND LIMITATIONS OF THE ENTIRE ALARM SYSTEM, REFER TO THE 
INSTALLATION AND SETUP GUIDE FOR THE CONTROL PANEL WITH WHICH THIS DEVICE IS USED. 

 

 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

165 Eileen Way, Syosset, New York 11791

Copyright © 2006 Honeywell International Inc.

www.honeywell.com/security

 

 
 

ÊK0020V2%Š 

K0020V2  6/06  Rev. B 

 

Summary of Contents for 5828V - Ademco Wireless Talking Keypad

Page 1: ...ds a system status request and displays and or annunciates the present status transmitted by the system 2 AC Powered Operation When powered by AC the keypad remains active at all times Any change in system status will cause the display to automatically turn on if blank and display annunciate the new status If AC power is lost the keypad will revert to battery powered operation until AC power is re...

Page 2: ... press 3 exit delay would be 3 times 15 seconds for a total of 45 seconds NOTE The Exit Delay programmed here should match the Exit Delay programmed in the control panel 0 default Press to continue Alternately flashes t3 and value selected 4 5828V only Press 4 Voice enable disable Press 0 to disable Press 1 to enable 1 default Press to continue Alternately flashes t4 and 0 or 1 5 Press 5 Wireless ...

Page 3: ...Kit on the next page It is recommended that three AA batteries be installed as a backup power source when using the Power Pack Desktop Mounting Kit SUPERVISION A 5828 5828V keypad low battery condition will be displayed as BAT on Zone 00 until the battery drops below a minimum level and the display goes blank The 5828 5828V does not display three digit conditions such as a keypad or receiver super...

Page 4: ...DA OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS 1 THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND 2 THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION THE USER SHALL NOT MAKE ANY CHANGES OR MODIFICATIONS TO THE EQUIPMENT UNLESS AUTHORIZED BY THE INSTALLATION AND SETUP GUIDE OR USER GUIDE FOR WARRANTY INFORMATION AND LIMITATIONS OF...

Reviews: