Honeywell 5103-5108, Operations & Installation Manual, Page: 5 / 12

3
1. To open safe enter the new pass code that was used to lock the safe in Step 1 of the
“LOCKING SAFE” section above (Figure 1).
2. Immediately after entering the code, press the “LOCK” key (Figure 2).
3. Lock bolts should receed into the unlocked position (Figure 3).
4. The LED will display and you can then pull door open using the handle located at the
bottom of the keypad (Figure 4).
NOTE: You can relock the safe by entering any 3-6 digit Pass Code followed by the “LOCK” key
The lock design allows for a new user code each time that the safe is locked
1. Enter any 3-6 digit Pass Code, for example “1”-“5”–“9” (Figure 1).
2. Immediately after entering the code, press the “LOCK” key (Figure 2).
3. Lock bolts should extend into the locked position (Figure 3).
4. The LED will display for 3 seconds followed by the active code entered as a reminder.
(Figure 4 & 5).
PRIVACY MODE: To prevent the LED displaying the pass code entered, press “CLEAR” prior to
entering a code.
LOCK SOUND: To turn “beep” sound On or Off, press the “CLEAR” button twice.
LOCKING SAFE
UNLOCKING SAFE
Figure 1
Figure 1
Figure 2
Figure 2
Figure 3
Figure 3
Figure 4
Figure 4
Figure 5
4
1
2
ABC
DEF
JKL
GHI
PRS
CLEA
R
LOCK
TUV
OPER
WXY
MNO
3
5
6
9
8
7
0