27
Activate adjustment mode:
The activated adjustment mode is indicated at the
reader by the bottom green LED that flashes briefly
twice followed by a long pause.
Activate adjustment mode:
a) In the "stand alone" programming mode (see
Chapter 7) or
b) In NetEdit (only when the reader is operated via
RS-485 at the ACS-8 from V06.xx upwards).
F
i
Activate
adjustment mode
LED indicator during the setting process:
maximum possible
range
yellow LED
top green LED
acoustic signal
The flashing rhythm of the green LED indicates
whether transmission is safe at many (a), a few (b)
or only at one (c) of the 16 possible power stages.
This is an indication of how much power is still
available up to the maximum possible distance.
If the transponder reaches the
, the green LED only flashes once (c). The
flashes additionally and signalizes that
a greater distance cannot be exceeded.
During adjustment, hold the transponder steadily in the reading range. We recommend
using a non-metallic object as a "spacer" between the reader and the transponder.
Adjust:
reader
-
As soon as the transponder is identified,
begins to flash.
Adjustment begins LED indicator see above)
-
After approx. 5 sec. adjustment is completed.
Acknowledgement:
- Brief
"
"
Important:
-
Hold a transponder at the desired distance to the
.
-
(
adjustment indicator goes off
- The
.
- The adjusted distance ist stores and indicated.
-
Remove transponder.
After a dead time of approx. 3 sec. the adjustment mode indicator
flashes again.
ID card
or other
transponder
F
i
a)
b)
c)
Adjustment mode
Maximum range
Transponder identification
Repeat adjustment
Deactivate adjustment mode
Adjustment can be repeated at any time.
Condition: The adjustment mode must be activated, the adjustment mode display must flash.
Adjust as described above.
The adjustment mode is deactivated via the programming or in the "stand alone" programming
mode (see Chapter 7.) depending on the type of activation.
Mounting and Operating Instructions - proX2-reader "Accentic" with keypad
