PROSiXGB
Wireless Glass Break Detector
Installation and Setup Guide
The PROSiXGB is a wireless glassbreak detector intended for use with Honeywell Home controls that support
PROSiX™ Series devices.
MOUNTING GUIDELINES
The PROSiXGB can be mounted
on the wall or on the ceiling:
•
within 7.6 m (25 feet) of the
protected glass
•
within clear view of the protected
glass
•
at least 2 m (6.5 feet) from the floor
•
at least 1 m (3.3 feet) from forced
air ducts
•
at least 1 m (3.3 feet) from sirens or
bells greater than 5 cm (2 inches) in
diameter
•
between the protected glass and
any heavy window coverings
•
when heavy window coverings are
present, the detector can be
mounted on the window frame
•
Avoid mounting the detector on the
same wall as the protected glass,
on free-standing posts or pillars, or
in rooms with noisy equipment (air
compressors, bells, power tools,
etc.), if this equipment is operated
when the detector is armed.
To remove the mounting bracket:
Turn the top of the detector 15 degrees counter-
clockwise and separate the mounting bracket.
NOTE
: Before mounting the device permanently,
conduct a sensor test (see controller’s
instructions) to verify adequate signal
strength and adjust the device location and
orientation as necessary.
The rear tamper plate MUST be mounted to a stud,
solid wood, or with a robust wall anchor.
