Honey Bee Grain Belt Plus 3055, Operator'S Manual

Page: 243 / 253

Honey Bee Manufacturing Ltd.
2007 Grain Belt Plus Supplement
Scenario 1:
The flotation restrainer pins are set too high and need to be either lowered, or removed
altogether and placed into the storage hole, to allow a full range of flotation.
To change the position of the flotation restrainer pins, refer to the “Header Flotation Restrainer
Plate” subsection in the LEVELING chapter of the operator's manual.
Scenario 2:
The link arm is set up too short (not pushed far enough in to the clevis pin slot). The clevis
end of the sensor rod must be pushed to the rear, into the slot of the sensor arm. If it is not,
you will get a very short or small voltage range.
To change this distance, see page 17, and proceed as follows:
1. Loosen the link arm set screw, located at the pivot.
2. Slide the clevis end of the link arm as far back as possible into the slot of the sensor
arm while in its mid (horizontal) position.
It is important to keep the rod and sensor arm in line with each other when
performing this procedure. If they are not in line when securing the clevis pin
into the sensor arm slot, the assembly will bind as it approaches horizontal.
3. Re tighten the rod locking coupler nut.
Rev. 01 - 04/25/08 22
Header Subframe - Right Hand Side