4 of 8
AII 20456 (9908)
© 1999 American Honda Motor Co., Inc - All Rights Reserved.
11. Carefully push the LED terminals into the 2-pin
connector from the kit.
Installing the Disarm Switch
12. Mark the dashboard lower cover in the area shown.
While wearing eye protection, lightly center-punch
the mark, and drill a 12 mm hole through the center-
punched mark.
20 mm
14 mm
12 mm
DRILL BIT
DASHBOARD
LOWER COVER
Intalling the LED
8.
Measure and mark the upper steering column cover
removed in step 7 and lightly center-punch the mark.
9.
While wearing eye protection, drill a 5.5 mm hole
through the center-punched mark. Remove all burrs.
10. Route the terminal ends of the LED through the hole
you just drilled, and secure the LED with the push
nut. Install the push nut securely.
5.5 mm DRILL
MARK
UPPER STEERING
COLUMN COVER
30 mm
CENTER OF
COLUMN COVER
LED
UPPER STEERING
COLUMN COVER
PUSH NUT
Insert.
LOCK
2-PIN
CONNECTOR
WHITE WIRE
RED WIRE
Insert the tabs into the
grooves, slide the lock
toward the front, and press
down on the end.
Firmly push the terminal into
the connector until they click
into position.
