© 2004 American Honda Motor Co., Inc - All Rights Reserved.
AII 27857 (0408)
7 of 8
ADHESIVE PAD
BOTTOM OF
CASSETTE PLAYER
ADHESIVE
BACKING
CENTER PANEL
Cut off the
bottom
rib.
Sectional
View
If you’re installing a cassette player, continue with
step 15; otherwise, go to step 17.
15. Using a utility knife, cut off the bottom rib from the
center panel at the lower edge of the audio
opening. Remove all burrs. Before attaching the
rubber pads, thoroughly clean the areas where the
rubber pads will attach with isopropyl alcohol.
16. Remove the adhesive backing from the adhesive
pad, and attach it to the bottom of the cassette
player in the area shown.
17. Slide the CD or cassette player into the opening of
the center panel, then install the four screws
provided with the CD or cassette player.
AUDIO UNIT
CONNECTOR
CD OR
CASSETTE
PLAYER
HARNESS
CLIP
WASHER-SCREW
CD player:
4 x 8 mm washer-
screw
Cassette player:
5 x 8 mm washer-
screw
CENTER PANEL
SCREWS (4)
(Provided with the
CD or cassette
player.)
Install in
the lower
hole.
CD OR
CASSETTE
PLAYER
18. Attach the harness clip to the rear of the CD or
cassette player with the washer-screw provided.
19. Plug the connector from the CD or cassette player
into the rear of the audio unit, and secure the harness
with the harness clip.
