Honda NX250 1989, Manuals

Page: 64 / 108

HYDRAULIC BRAKE
MASTER CYLINDER
DISASSEMBLY
Drain brake fluid the hydraulic system (page 14-3).
CAUTION
* Avoid spilling fluid on plastic, or rubber parts. Placea
rag over these parts whenever the system is serviced.
Remove the view mirror.
Loosen the brake hose joint nut and disconnect the brake hose
from the joint.
Disconnect the front brake light switch wires.
Remove the master cylinder.
CAUTION
• When removing the brake hose cover the end the hose to pre-
vent contamination.
Remove the brake lever by removing the pivot nut and bolt.
Remove the brake light switch by removing the screw.
LEVER
Remove the piston boot.
Remove the snap ring from the master cylinder.
TOOL:
Snap ring pliers
0 7 9 1 4 - 3 2 3 0 0 0 1 or
equivalent commercially
available in U.S.A.
SNAP RING
SNAP RING
PLIERS
BOOT
Remove the following:
— washer
— master piston
— spring
Clean the master cylinder, reservoir and master piston in clean
brake
SPRING
MASTER PISTON
14-6