Honda NC700 2012, Service Manual

Page: 445 / 773

12-90
dummyhead dummyhead
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
4. VS Sensor Output Line Open Circuit Inspection
Connect the ECM test harness to the PCM
connectors (page 4-14).
Check for continuity between the wire harness side
VS sensor 3P (Black) connector [1] and test
harness [2] terminals.
Is there continuity?
YES – GO TO STEP 5.
NO – Open circuit in the Pink/green wire
5. VS Sensor Output Line Short Circuit Inspection
Check for continuity between the wire harness side
VS sensor 3P (Black) connector [1] terminal and
ground.
Is there continuity?
YES – Short circuit in the Pink/green wire
NO – GO TO STEP 6.
6. VS Sensor Inspection
Replace the VS sensor with a known good one
(page 22-18).
Erase the DTCs (page 12-13).
Test-ride the motorcycle and stop the engine.
Read the DTC with the shift indicator (page 12-13).
Is DTC 66 indicated?
YES – Replace the PCM with a known good one,
and recheck.
NO – Faulty original VS sensor
DTC 67 (FRONT WHEEL SPEED
SENSOR NO SIGNAL)
• Before starting the inspection, check for loose or
poor contact on the front wheel speed sensor 2P
(Blue), ABS modulator 25P and PCM 33P
connectors, and recheck the DTC.
• If the PCM is replaced, perform the following:
– Key Registration Procedure (page 23-6)
– Clutch Initialize Learning Procedure (page 12-120)
1. DTC Recheck
Erase the DTCs (page 12-13).
Test-ride the motorcycle above 18 km/h (11 mph).
Stop the engine.
Read the DTC with the shift indicator (page 12-13).
Is DTC 67 indicated?
YES – GO TO STEP 2.
NO – Intermittent failure
Connection: Pink/green – A32
A32
P/G
[2]
[1]
Connection: Pink/green – Ground
[1]
P/G