Honda NC700 2012, Service Manual

Page: 420 / 773

12-65
dummyhead dummyhead
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
2. Shift Control Motor Condition Inspection
Remove the shift control motor (page 12-109).
Connect a fully charged 12 V battery [1] to the shift
control motor [2] 2P connector terminals to check
the motor operation.
Change the battery connection to check the reverse
operation.
Does the shift control motor turn in both
directions?
YES – GO TO STEP 3.
NO – Faulty shift control motor
3. Shift Spindle Angle Sensor Condition Inspection
Check that the shift spindle angle sensor is installed
properly.
Is the shift spindle angle sensor in normal
condition?
YES – Faulty shift spindle angle sensor
NO – Install the shift spindle angle sensor
properly.
DTC 24 (SHIFT CONTROL MOTOR
DRIVE CIRCUIT)
• If the PCM is replaced, perform the following:
– Key Registration Procedure (page 23-6)
– Clutch Initialize Learning Procedure (page 12-120)
1. Shift Control Motor Line Open Circuit Inspection
Connect the ECM test harness to the PCM
connectors (page 4-14).
Disconnect the shift control motor 2P (Black)
connector.
Check for continuity between the wire harness side
shift control motor 2P (Black) connector [1] and test
harness [2] terminals.
Is there continuity?
YES – GO TO STEP 2.
NO – • Open circuit in the Pink/blue wire
• Open circuit in the Yellow/blue wire
[2] [1]
Connection: Pink/blue – A1
Pink/blue – A2
Yellow/blue – A4
Yellow/blue – A15
P/Bu
[2]
A4
Y/Bu
A2 A1
A15 [1]