HS624 • HS724 • HS828 • HS928 • HS1132 SNOWBLOWERS
11 of 17
8. Install the cable
ties as shown.
9.
All models except HS1132:
a. Place the grommet on the throttle cable, and position it
at the cable sleeve, as shown.
b. Install the air intake cover, using the two 6 x 8 mm
flange bolts. Be sure the grommet is seated in the
edge of the cover.
NOTICE
If the grommet is not properly installed, the cable will
not be correctly positioned and can interfere with the
throttle linkage inside the cover.
c. Tighten the two 6 x 8 mm flange bolts to the specified
torque.
TORQUE: 11 N•m (8 ft-lb)
MEDIUM CABLE TIE
HS1132 only: Clamp the
choke cable and throttle
cable around the upper
handlebar.
LONG CABLE TIE
All models: Clamp the HST
oil hose and shift cable to
the handlebar strut.
SHORT CABLE TIE
(factory installed)
6 x 8 mm
FLANGE
BOLT (2)
GROMMET
THROTTLE
CABLE
CABLE
SLEEVE
AIR INTAKE
COVER
CABLE
SLEEVE
GROMMET
AIR INTAKE
COVER
THROTTLE
CABLE
AIR INTAKE COVER
HS624/724 ONLY
HS828/928 ONLY
Summary of Contents for HS1132
Page 18: ......
