Swift Chassis DB-1 & DB-6
L15A7 Engine Installation Manual
12
8/2010
Install Fuel System
– DB-1 & DB-6 cont’d
Using the pipe thread sealant, install
the 5/16
‟ Barb to AN-4 ORB adaptor
into the housing, on the fuel cell
(bottom) side. This will connect to the
fuel pump.
NOTE:
Be sure the regulator is
sending excess fuel back into the tank
(down) and not into the cover (up).
Install the fuel pump harness into the
AN-6 hole. Ensure the O-ring is in
place.
Snug down the connector.
Loosely install both 90
°
AN-4
bulkhead fittings in to their respective
positions.
Use the AN-4 crush washers between
the flange and the jam nuts.
