Honda Goldwing GL1200 ©
17
Route the switch wire down the handlebar with the other wires and hoses and cable tie in a couple of places.
Route the wire with the other wires under the steering head cover then down and back inside the left fork leg.
Route the wire down the left side of the frame. The plug should rest near the in-line cable adjuster in the pull
throttle cable.
Installing the computer.
Note: - Some versions of this motorcycle have a seat adjustment release lever on top of the fuel tank. If
your bike has this refer to the addendum on page 28 for computer mounting details.
Clean the top of the fuel tank in the area between the front seat mount and the filler cap with methylated spirits
(wood alcohol).
Peel the paper of the two self adhesive pads on the underside of
the computer and place it on the tank so that the side sits against
the seam in the tank and the front of the computer is about 50mm
(2”) behind the fuel filler spill tray.
Check that the three position sensitivity switch (the small slide
switch to the left of the 12 pin plug) is in its middle, medium
(M), position. The other positions are low (L) and high (H).
You will notice that the label has L, M & H marked on it.
Installing the wiring loom.
Computer connection.
Plug the 12 pin computer plug into the computer. The latch goes to the bottom.
Switch connection.
Route the loom to the left behind the fuel filler spill tray and
under the drain hose, then forward on the left side of the spill
tray, through the loop formed by the carburettor cable, then
forward to the switch wire plug.
Connect the switch wire to the loom.
Earth (ground) connection.
Remove the bolt with the earth (ground) wire under it, and place the
earth connector (green wires) on this bolt.
